KiWinUS's latest activity

As a follow-up: I got around to making a list cover for the clutch-flywheel to mate the Speedway Motors adapter bellhousing with the GM...

Basically, if you want to retro fit a 255 crank into the 21 stud block, you'll need to perform the following operations; shorten the...

There is only 1 red top 6 volt optima battery. I have one that is close to 20 years old and still good with no battery tender Sorry I...

Kiwi, thank you

Yes in the classified section. Not here in forum.

Yeah, I'm running a Scat 4"stroke crank in a 37 block with 3 3/16 pistons; 255 cu in. The Scat crank as supplied, did not fit the block...

One challenge is getting bored large enough to fit suitable connecting rods down through. Your 21 stud bore started at 3 1/16” you need...

We shall see, I mean, I wouldn’t mind having one or two of the pickled engines just to see what kind of shape they’re in. I just don’t...

I have tried to sell a lot of this stuff at very low prices with zero interest. Some I have given away to "good guys" and was happy...

Just a suggestion but a piece of PVC tubing dipped into the barrel all way to bottom like a straw block end and pull out to check for...

Easy click on 3 dots at lower left of your post next to the word Report. will give you options

I would advise you to not buy this stuff. Especially considering where you are located. Parts value has plummeted and most likely will...

Time and effort vs. investment. Plus the oil mess challenge and disposal. In my opinion the entire pile would have to be dirt cheap as...

There is a cam grinder in CA that will grind the 8CM Merc specs but with more lift (.380"). I have one of these grinds for a 59AB. Not...

Thanks All. Based on an earlier reply I just ordered a rebuilt complete distributor from Mike at Nextgen. It should be here Friday. Will...