Recent content by KevinH944

If your car has a thermostat added, it could be malfunctioning or not allowing a high enough flow.

Turn the rubber ball inside-out first, then "unwrap" it around the ball.

I had a similar issue with a noise that went away when one of the clutch springs came loose and fell out, but I didn't know what it was at the time. A few months later another let go and I had to replace the clutch disk. I took the advice I found here on the Barn and used the better disk with...

I found it easier to first turn the rubber ball inside out, then just "unwrap" it around the radius rod end.

In my limited experience, the spring you found is a clue. I had the same experience with no gears at all when the springs around the outside of the clutch disk came out, allowing the center of the disk to separate from the outside. Once I had it all apart, I found more clutch springs and...

This may not be your problem, but I had a similar issue where I could not get the gauge to stop weeping. On a reproduction gauge that come on my car, I found that the inner nut did not have the correct threads and would never tighten properly. I ordered a correct nut from Bert's and that...

In our group we do all use the paid version, we found it was worth it.

With another car club, we have had good success with a couple of iPhone apps that allow you to create a route, then share the gpx file with other users of the apps. They both provide turn by turn navigation once the route is loaded, and you can add stops along the route. One is inRoute...

That's the sound I have on my 28. What should I do to correct that?

I have family in the Hershey area and travel there regularly. Here are two that I recommend that are near Hershey at the 83 / 283 interchange: Lancaster Brewing Company 469 Eisenhower Blvd Harrisburg, PA 17111 www.lancasterbrewing.com Gilligans Bar & Grill 987 Eisenhower Blvd Harrisburg, PA...