Recent content by KendraFowles

Wanting to buy - good used original or NOS center grill stainless steel trim for '36 Ford passenger car. Can't be repro. Thanks

I know this sounds odd but I want to buy a box full of air. Modern repro 1936 Ford V8 Passenger Car hood ornaments are usually shipped in a styrofoam container molded to protect the hood ornament (and especially the fragile "V8" stems) from breakage. I'd like to get one of these empty...

Found one here, no longer looking. Thanks Ford Barners

Looking to buy an original 36 hood ornament, can be in rough shape (broken V, pits are ok) but it cannot be a repro. thanks

Looking to buy one set of good original 36 front bumper brackets. Part number 68-17766 & 68-17767. Thanks

Looking to buy an original '36-37 dashboard light switch. 1935 appears similar but is not correct ('36-37 on/off is opposite of '35). thanks

Looking to buy an original correct lighter housing for '35-36 Ford, not repro. Thanks

Looking to buy a good original 35-36 striker plate for the rumble lid. Ford 48-713780-E should be iron, not interested in stainless repro. Thanks

1936 Cabriolet correct restoration. Tailpipe sticks waaay out and obviously needs to be shortened. Everything else in the exhaust system fits well (that took quite a bit of work). I searched and couldn't find this measurement. What's the correct length for the tailpipe, measured from the...

I found one, here on the Barn. No longer looking. Thanks!

I need an original 1936 throttle linkage, must be 3-3/4" long as pictured. 1935 is shorter and won't fit. I don't know if 1937 etc. uses the same part. thanks, Ken

Found one here, no longer looking. Thanks Ford Barners! Ken

For correct restoration, looking to buy a late 1936 oil pan. If you have one to sell, let me know the details. Thanks, Ken

Looking to buy a good original 1935-36 male dovetail. Needs to be "centered" type similar to attached photo, not an "offset" dovetail. I don't want repro. thanks, Ken

Grommets arrived. Question: roughly how far (how high) above the top-header tin should the bumpers/grommets sit? thanks