Recent content by jwhite1149

  1. jwhite1149

    Letter 'D' stamped on Rad.?

    37 PU rad. has the letter 'D" stamped on top right inside corner ?? Meaning?
  2. jwhite1149

    Cast vs Stamped bell housings

    What is the functional difference between a "cast and stamped" bell housing? What makes one work and the other not on an 8BA install?
  3. jwhite1149

    Oil pan clearance

    Installing 8BA in 1937 pu will the oil pan clear? If not what will?
  4. jwhite1149

    Hot engine

    ford3, Thanks, you are right. To all others thanks for the info.
  5. jwhite1149

    Hot engine

    You guys are over thinking my question. My 37 pu has an overheating problem. I've done all the things recommended on The Ford Barn but, was thinking.........how hot can this flathead get. I have a distributor coming from Bubba's, have done the flush, so on and so on. I do not want to damage my...
  6. jwhite1149

    Hot engine

    How hot can a flathead get before it will lock up?
  7. jwhite1149

    How do I give a block away ?

    Elwood, PM and e-mail sent. Thanks Jim
  8. jwhite1149

    1936 Ford Pickup

    I have a little 37 pu, love my truck.https://www.fordbarn.com/attachments/141900/
  9. jwhite1149

    Vinegar flush

    Mike, Yes my radiator boiled over the first time, it took two days to clean up and polish my paint. I may try vinegar one more time, then use the baking soda. I removed a lot of rust but like you I would like it a bit better. Jim
  10. jwhite1149

    Vinegar flush

    Over the past few weeks I have flushed my radiator/engine three times with vinegar. Drained and flushed with water, refilled with vinegar, etc. etc. Fresh vinegar has been in the radiator over 20 days. I have used 15 gallons of vinegar and 200-400 gallons of water. I use a running water hose in...
  11. jwhite1149

    NAPA condenser

    Thanks guys, good info. jim
  12. jwhite1149

    NAPA condenser

    Is the NAPA condenser #IH-200 used for 6 or 12 volts, I have the 6 volt system. I'm new at this. Thanks
  13. jwhite1149

    Head torque?

    How much do I torque the 37 head bolts and what is the pattern? Thanks
  14. jwhite1149

    Normal temperatures

    G.M. Thanks for the info, I'm thinking of sending the distributor to Bubba's shop for a rebuild. My truck starts quickly and runs well, but I'm I have been told my timing may be off. How much effect can this have on the temperature of the engine, 10 or 20 degrees???? I'm in Texas, very near...
  15. jwhite1149

    Normal temperatures

    That temp on the head below the hose is 203-208 taken with my infrared thermometer. Below that on the center of the exhaust manifold temp is 350+ is that too hot, could it be the cause for the head temps? Have new water pumps, flushed radiator/engine with 4 gals. of vinegar (ran it for four...
Back
Top