Recent content by jw hash

the header trim goes above the hinge and rubber. it goes in first. best way to do it install the trim than install the rubber and hinge.

Re: Driver’s Door Mechanism and Window - Slant I find working on the SW front doors. pull the glass out first than you can get to the window Reg, and the door latch. otherwise, you will fight it the whole time.

well said cadillac, I run into that a lot with a new belt. no big deal sometimes I put the belt the top of the water pump and on the generator pulley and use the generator to pull the belt on. I just did that one hour ago.

you have an early 30 fixed seat. if you want to change it over to an adjustable seat. you need to change the package tray all the metal floor panels except the rear rumble seat riser. the late 30 and 31 front seat riser are the same as the late 30-31 coupe. the seat frame itself is the same as...

the fiber washer is there to seal off the opening and keeping the screw from shorting out.

I would like to get Dick Crabtree contact information. thanks John thanks Paul

yes, it is a Model an Axle

can you take a picture of the head gasket with your cell phone and sent it to me John Hash

I received mine today and installed in the new binder already. the JSC did a fantastic job. thanks Guys.

you might check with Olson`s gaskets in Port Orchard if you want to go copper it is 509C I was there Wednesday and picked up some 509G`s

1930 Cabriolet rumble handle with the oval speedo. the later ones with the round speedo had the removeable lock.

I have straightened a lot of frames for over 50 years. some are harder the others. sometimes you need to remove the body. most of the time there is no need to. on the Model A frames that I have done; I have never had a comeback. I made the video on fixing the sag on the Model A frame. to help...

I will try to be there.

Re: Fuel line question the gas line should extend at least 3/16" out of ferrule. if not, it will leak.

the 28-29 coupe trunk drip rail is bolted in place. with screws and nuts. the Cabriolet`s use the same one. unless they cut the 1/4 panel.