Recent content by jrvariel48

Unbelievable job!! Thank you!

I'm looking for a decent chrome bumper. I don't need one that's show ready. Just a little beat up for a driver. send pictures to bigfatbubba35@gmail.com Thanks Joe

So sorry for your loss. My condolences to your family. He'll be missed here for sure

gone

I actually left him a message yesterday morning and he returned my call within a few hours.

So sorry to hear this. Ron and his knowledge were a huge part of helping me put my motor together. Always a gentleman. You'll be greatly missed by everyone.

I welded the threaded part of a spark plug to a piece of 3/8" threaded rod and made a crude slide hammer out of it. You gently slide the weight upwards to a washer and nut at the top end of the threaded rod. You can start in any of the spark plug holes and move the assembly to other holes until...

Happy birthday BOB! Get that 32 goin'!!

KiWinUS ground a stock 8ba cam to L100B specs for my blower motor and I think it runs perfect!

Here's what I got Fordy. I hope this helps Thanks

That's exactly what it was trying to do Coop! I jacked the car up on the frame until the wheels were off the ground. (Thanks pistonbroke & 19Fordy) Then I jacked up the axle a little. There's a sweet spot in there where the spring is almost completely relaxed. Then i installed a hydraulic ram...

Great thanks everyone!

I need to remove the pass. side perch bolt to make a repair to the shock mount. The car is a 35 Coupe with split wishbones. I have the car on a 4 post lift. I started to press the pin out and it's moving without a major fight because I greased it when I installed it 10 years ago. Question is do...

Looking for a 78- or 11A- arm

I have a set of 8 used conrods from my 51 8Ba Buyer pays shipping. Email for pictures jrv51765@gmail.com