Recent content by Josh Randall

Looking at the lean in those extensions they must not be very rigid. Mine are and without any sway. Randall

Why do you say that? There is 1-1/2" of thread engagement. Show us how you do it. Randall

Lift points I use. With extenders that came with the lift. Randall

Found, thanks guys!

I used a Cone Point set screw from Fastenal, because the original would turn the Distributor when tightened down. Might try that if all else fails. Randall

FOUND Thanks Randall

Another endorsement for the JB Weld. I repaired a Ford 8n tractor block 20 years ago and its still good. I've also had good luck with Bar's leak tablets. Randall

Smh

I had a 53 Ford pickup that sounded similar. It turned out to be a small vacuum leak. Randall

Nice parts! They look like speed!!

Replacement blocks were not stamped according to this. http://www.fordgarage.com/pages/diamondblock.htm

That's how I did it.... I also had to hold the joint together tightly to get the threaded plug started. Randall

Other end.

Until Corley checks in this is what worked for me. Red positive... green negative Negative ground. I finished the machine work this weekend I used the info submitted by Corley. Randall