Recent content by johnr6776@gmail.com

  1. J

    Broken wheel spoke

    The spoke has a clean break near the middle. I can put the spoke back together and only a hair line crack shows but it comes apart again when driving. Can a spoke be replaced? I think that I will purchase a new tire and put the broken wheel back to being a spare tire. Sent from my iPhone...
  2. J

    Broken wheel spoke

    I put on my spare tire and found a broken spoke. Can it be repaired? Sent from my iPhone using Tapatalk
  3. J

    Vendors

    I want to buy from a company that refuses to sell something of bad quality. I use Bratton’s because I have noticed items that they don’t offer. I appreciate that. Sent from my iPhone using Tapatalk
  4. J

    Do you use Mounted Dripping Oil Catch Pans?

    Are you talking about the rear main janitor? If so, I have one of those but never used it. The one that I ‘m talking about is much larger and yet it allows the oil and transmission fluid to be changed without removing drip tray. It is first rate. Sent from my iPhone using Tapatalk
  5. J

    Do you use Mounted Dripping Oil Catch Pans?

    I haven’t seen the one you are talking about. I will look it up to see how they compare. Apparently they weren’t available when Mike Kemp made the one that I have. I’ve owned it for a few years. Sent from my iPhone using Tapatalk
  6. J

    Do you use Mounted Dripping Oil Catch Pans?

    I purchased a very nice catch pan that was made by Mike Kemp from Mooresville,IN. He sells Omega leakless water pumps for Model A’s. He designed and manufactured several pans that fit under the engine and transmissions so that the Indianapolis Motor Speedway would let club members tour the...
  7. J

    Condenser Capacitiance.

    Who sells a top quality poly film condenser and what mfd is needed for a Model A? Sent from my iPhone using Tapatalk
  8. J

    Using a 12 volt Nappa coil with a 6 volt electrical system on Model A

    Very good info. Thanks Mike Sent from my iPhone using Tapatalk
  9. J

    Using a 12 volt Nappa coil with a 6 volt electrical system on Model A

    No resistor. Sent from my iPhone using Tapatalk
  10. J

    Rough Idle After Warmup

    My experience with cracks is just the opposite. Metal expands and closes the crack. Sent from my iPhone using Tapatalk
  11. J

    Using a 12 volt Nappa coil with a 6 volt electrical system on Model A

    I don’t know. What would happen if you use a 6 volt coil for a 12 volt system? I’m using the 12 volt with a 6 volt system. It works but there are some strange things happening. When I start the car the lights and horn work. After I take a nice ride, the lights and horn don’t work. Later...
  12. J

    Condenser Capacitiance.

    Do you sell Model A coils that test to your specifications? Sent from my iPhone using Tapatalk
  13. J

    Using a 12 volt Nappa coil with a 6 volt electrical system on Model A

    That should work. The reason for using the Nappa 12 volt coil is that they don’t break down due to heat. This is for touring A’s. Sent from my iPhone using Tapatalk
  14. J

    Using a 12 volt Nappa coil with a 6 volt electrical system on Model A

    What potential problems can this cause? Sent from my iPhone using Tapatalk
  15. J

    Pop out ignition

    Nurex Sent from my iPhone using Tapatalk
See more
Back
Top