Recent content by Joef21

What's the diameter of your cap. Does it have any notches and if so where.

I have had problems with some repo distributor bodies. When you put them on and clamp them with the top plate. It pushes down on the bottom plate advance, retard arm which them causes the point open to the point they will not close. If this is the case you will need to deepen the slot on the...

Check your points gap.

Did you put a gasket between belhousingand engine. If not the will leak there. Also check for a cracked belhousing.

If it turns out to be the ground on the horn switch, use a electronic relay available thru Seders.

If you have certain later ford drums with your hydraulic brakes you might need spacers behind your wheels, unless the adapters you mention are these spacers.

If all the above does not find the problem , when it gets warm, run a compression test.

There is a model a club in Albany, OR. They have close to a hundred members. There used to be a club in Salem. I don,t know if it is still active.

It's not usually the tire that's blows out but the tube inside. I would dismount the tires and check the tubes.

If it is crack into the exhaust valves you won't see it in the oil, but you should see a white exhaust from your tailpipe if you run antifreeze in your cooling system.

Someone did hack EBAY several weeks ago. You probably got a message from ebay asking you to change your password.

I would add the level of expertise of the individual submitting the problem.

Bypass the switch. If the fuse does not blow, you know the problem is with the switch.

Front king pin bushing, nos distributor bushings.

There are manifolds that route the air down instead if through the firewall. They connect to this floor vent. They hane both cast and sheet metal attachments as well as cast iron heater manifolds. I use the a cast iron manifold on my car.