Recent content by JLford

Btt

WTB the updated steering linkage made by Fatman for a 1951 Ford.

WTB the updated steering linkage made by Fatman for a 1951 Ford.

Hi everyone, I recently replaced the heater core in my 1951 Ford Victoria. The green bible says my engine should accommodate 5 gallons of coolant, yet I was only able to fill it with just shy of 4 gallons. The heater control valve is functioning, and the thermostats didn’t show signs of...

Got it, will definitely look into Eaton. Thanks for the suggestions.

PM’d you!

Hey everyone, I was hoping someone could advise me on coil spring options for a 1951 Ford Victoria. I am aware that Aerostar springs bolt in, and I'm interested in the improved ride quality achieved from progressive coils, but I am looking for stock ride height. Anyone know of any similar...

Hi Everyone, Just got back from Hershey and am in full Ford mode! Finally pulled the engine out of a project '52 Ford Victoria (anyone interested in a rolling chassis?) with the intent to rebuild it for a '51 Ford Victoria. I know Walt DuPont is the authority on Flatties but I'm not sure if...

Thanks for the reply flatford8, I'm inquiring because on some other forums I read about this specific brand (cool carb) melting. It wasn't on a flathead though.

Hey Everyone, Just wondering if anyone has any experience with running a cool carb heat shield on a flathead? Thanks!

Thanks JSeery, that sounds like a pretty accurate description of our box.

Hi All, My father and I rebuilt a 1951 Ford Victoria steering box this weekend. Upon completion, the steering wheel feels tight to turn in the center of the turning range (when turned to favor either side, it becomes easy again). We adjusted the sector shaft to the best of our ability while...

I didnt think so- Thanks Ross F-1

Hi All, Just bought a new clutch release bearing from shoebox-central. There is play between the bearing and the hub, and there is audible grinding when spinning the bearing. Just wondering if this is normal? Thanks, Justin

Thanks for the input! I'm leaning toward bushings, even though they aren't original to the car.