Recent content by jimhatt

$2500 or best offer

I have an early v8 201 halibrand qc center section [banjo] w/ford script pinion gear ,lower shaft and 1 set change gears culver city rear cover and 1 bare ring gear and 1 ring gear with carrier assm 3.78 ratio have not checked spur gear set number or ratio Was in a 3/4 midget never damaged or...

Did you get my pm Jim

If they are pin holes clean it tin it and solder them closed and sand flush neutralize with baking soda done it lots of times

I have a 29 rpu cab in prime on a rotisserie that has only had the panel under the seat replaced let me know if I can help Jim 5046288268

do you still need them I have a pair of unused repos Jim 5046288268

If you still need one let me know used not rusty and cheap Jim

Re: Aluminum Flathead Heads I have1 Made in Canada head cast # C7RA-6050-B but didnt count studs Let me know Jim

I Think I have a pair of spindles not sure of year let me know if you still them and I will check Jim 504 455 3369

Dave I have 1 made in canada head cast # C7RA-6050-B let me know Jim

I have a halibrand qc center section and r+p w/ pair of spur gears It was in a 3/4 midget the ring gear is the same as a model a I do not have the carrier I do have the coupler shaft and the coupler but not the housing let me know Jim cell 504 628 8268

need rf frame horn for 29 rpu need cut behind crossmember and 2 front bumper brackets thanks Jim 504 628 8268

need rf frame horn and 2 front bumper brackets for 29 rpu need horn cut behind frt crossmember thanks Jim