Recent content by Jerry Huntngton Beach

Good Afternoon, My fully modified flathead will start but will not continue to run. I have checked timing, gasoline in carb etc... and everything appears to be OK. I have an electronic distributor that has functioned for the past 3 years. Any suggestions? Appreciate your help...

Engine is at top dead center and am attempting to install Mallory correctly. What position should the Rotor be in? Appreciate your information. Jerry! !

Sold !!!

Sold ! ! !

Bruce Robinson 16 valve DOHC machined casting. 714 - 848-7167

Complete head & chain housing, machined, pressure tested & fluorescent penetrant inspected. 714 - 848-7167

Casting Set and Chain Housing. Fully machined. Ready for final assembly. $1200.00 OBO 714 848-7167 email: ouches@socal.rr.com

Early v-8 Columbia 2 speed rear end. Rebuilt by Doug Lindow. "Bullet -proofed". Price does not include shipping and handling. Reasonable offers can be accepted.

Block front tires. Suspend rear frame rails on two (2) jack stands. Start engine, shift to third gear and operate Columbia controls. Right wheel should be rotating.

Contact Engine Supply, Santa Ana.

I use Engine Supply, Santa Ana, CA for all my machining and modification requirements. Owner is very knowledgeable with Model A experience and state of the art equipment. Ask for MIKE.

Contact "Engine Supply" Santa Ana, CA. Mike is very knowledgeable and skilled with Model A and B engines. Facility has excellent equipment. Phone number is 714-556-0310.

I have a drawing that reflects the valve cover hole pattern. E-mail me at ouches@socal.rr.com. Jerry Hurt

Try applying "GIBBS" penetrating solution. Follow instructions on can. Jerry

How long is the shaft? I have a shaft leaning up agsinst the fence that I will give away. Need to know how long you need. Jerry Hurt ouches@socal.rr.com