Recent content by JamieMorgan

Thanks briphaeton. The blueprint bore is so small that the outer casting is smaller than the 3 7/8" bore. I'll need to come up with a way to figure out what the casting thickness is around the cylinder bores. Does anyone have a really good photo of the bottom and timing cover end of a bare...

Here is what I did last night. No dimensions yet, just trying to get it all sorted out. The blueprint has a lot of information, but it is scattered all over. Very big puzzle on small computer screen. My dad is having it printed out so I can hang it on my wall. This should make it easier to see...

Hi Brian I am referencing everything off the center line of the crank and the center line of the cylinder bore which are 0.125" offset from each other. I was given that drawing and don't know it's original source. I'm drawing the top of the block now and if the top is an exact 7.8125" wide...

Today is Christmas and you Brent are Santa Claus. You have made this project much easier. Thank you.

Hello everyone. I am 15 years old and a freshman in high school. I received a 3D CAD modeling software for my birthday last summer and would like to create a detailed 3D computer model of the Model A Ford engine block to start with and then add parts from there. Unfortunately I do not have...