Recent content by Jagawar

Well, I completely rebuilt the front end on the 38 I ordered a new, improved drag link as a matter of course. (Ebay) Set the toe in at exactly 1/16th full left turn; drag link scrapes the tie rod I have the bend in the tie rod pointing down as to give it clearance. no avail; new drag link is too...

I looked all over the carb and manifold I dont see any vac ports

I think I have electric motors for the wipers ?

85hp

Hello folks, I want to set up my carburetor with a vac gauge. Where can I hook it up? I don't see any ports ?

I just bought one. Cheaper than hiring an assistant

Its definately a 85 HP car and 81 a not 82A

I read On line to do the whole car front and back seats No door panels 8-10 yards with door panels on a two door its about 15-16

Thing is I have the orig seats in my car only has sun damage on top of rear seat backrest,all orig door panels as well.

It's an 81 A 85 HP still trying to post some pixs on this site . I am almost 80 yrs old myself, so I'm a little slow in my computer savvy.

No it's an 81 A 85 HP My mistake

Thanks

Where doe's it hook up to?

Worked like a charm TY for the info. However, new mounts (bottoms) ae a little different inside diameter. Original bolt uses a sleeve; new mounts just the bolt. I want to reuse the orig bolts; so far, no luck getting the sleeve off. Tried BM heat; not enough; I am afraid I'm not getting it...

So it's an accelerator footrest?