Recent content by Ideucev8

  1. I

    Axle Housing Repair Sleeve

    Wow, thanks for all the answers. This gives me plenty to look into. thanks , Phil.
  2. I

    Axle Housing Repair Sleeve

    Tim those are too small in diameter.
  3. I

    Axle Housing Repair Sleeve

    Ken, I was in contact with John a couple of days ago & he informed me that he is not having any more made. I had one made in New Zealand & it lasted 4000Miles, it was soft just like the two that I fitted from CW Moss a couple of years ago.
  4. I

    Axle Housing Repair Sleeve

    Out of stock. I have two of theirs that I brought a couple of years ago & they are soft I can file them.
  5. I

    Axle Housing Repair Sleeve

    No to repair the outer end that the hub bearing runs on.
  6. I

    Axle Housing Repair Sleeve

    Hi, Can anyone please advise where I can obtain a good quality Hard axle repair sleeve. John Connelly no longer stocks these & can't recommend anywhere to get one. Thanks Phil.
  7. I

    32 rear luggage bar, welds

    Hank, I have a luggage bar that came off a original 4 Door sold new in New Zealand & it would have come from Canada, the bar looks just like yours, with the same crappy welds. Phil
  8. I

    239 pistons in a 221

    As Brian say's sonic test the cylinder wall thicknesses. I've been running a 81A bored 3 3/16" +.020 for over 20 years Phil.
  9. I

    pressure plate specifications

    I'm running the same set up as 51504bat in my 32 pickup, done 15,000 miles with no problems. I know of 2 others running the same setup down under with no problems. Phil.
  10. I

    Trans 81A- 7222 detent balls

    Barry, I brought some balls & springs from Michael Driskell 3rd Gen Automotive a while ago. Same problem, small balls shifter sloppy when assembled. threw in the junk bin. Phil.
  11. I

    53 Mercury unequal steering

    You should also check that the tie rods out by the wheels are both adjusted to the same length. Phil.
  12. I

    What’s this spring do

    Re: What’s this spring do If you squeeze the sides of the hoop part together it shortens the hinge pin so that you can dismantle the hinge. Phil.
  13. I

    Oil leak

    Did you check the rear main bearing clearance? Also have you checked that the drain slot & drain tube in the rear main bearing cap is not blocked. I have found this problem before on a shop built engine. Phil.
  14. I

    Remote rod rumble seat 33 5w

    All the LHD one's that I have seen have had the handle on the passenger side so that the driver can operate it easily. The rod pulls not pushes. Would be a bit awkward to operate if it's behind the driver. Phil
  15. I

    Remote rod rumble seat 33 5w

    The bracket screws onto the outside edge of the vertical piece of wood on the side of the window. Phil
See more
Back
Top