Recent content by HP Hunter

Apprecaite all the help but deal fell through on car, oh well. Would have been moved from Pa. to Tn. Harry

Would like some help from anyone with first hand experience having a car transported? Which company and any issues? Looking for enclosed shipping only. Harry

You need to back em off first one at a time and then retorque em. Not just try to retorque em. Harry

This is the wrong size valve for the original flatheads. Harry

This is the best way to set the valves and the easiest. Harry

I would listen to jseery here ^ raelly good advice. Harry

Its called stitching weve been doing it for years on all different blocks. The plugs come in different sizes, small to large. All are tapered. Harry

At the raer it may work easier just back drilling the plate through an old bellhousing? Harry

Really a unecessary tool in my opinion, 2 full turns on motor and valves are done Harry

Wix just opened a big manufactureing plant in China last year. You will need to be careful using them now. Harry

Better check the mains to, probably ng also. Need to find out why? Bearings dont just melt. Harry

Lay the heads on top turn the motor over without any head gaskets. If it goes without hitting anything youll be ok when the gaskets are there. Hopefully your using an aftermarket gasket. Harry

Large chambers with most bigger engines. Harry

Havent seen any Flathead rear main rope seals needing to be cut. I use the felpro sets. Never cut the fronts also. Harry

The 7/16 helicoil kit for the 7/16 thread repair is fine, not any problem. Harry