If it was in my neck of the woods and the body is what it appears to be. It'd be mine and I already have a banger pickup I'm getting carried away with.
I sold my last model A about 8 years ago and recently became interested in having a Model A again. Doing a little research i came across your improved engine. I then became real serious about an A or B car. I even put a 600hp car on the market.
I believe in the superiority of your block and...
I've had 3 As so far and have had the transmission experience. I'm reasonably sure I'm going to increase the Bangers power and I want to add the 5 speed and be done with it. The next one is going to see quite a bit of daily driving in season. If I'm lucky I'll end up with a Model B.
I've had 3 As so far and have had the transmission experience. I'm reasonably sure I'm going to increase the Bangers power. I want to add the 5 speed and be done with it. The next one is going to see quite a bit of daily driving in season. If I'm lucky I'll end up with a Model B.
Thanks! I'll consult with you when the time comes. I'm on the hunt right now for a good A or a Model B if I'm lucky. I'm reasonably sure I want a 2.95 1st gear.
The TKO is not the trans I’m inquiring about. The TKX is a relatively new trans from Tremec and dimensionally very similar to a T5. I like the gear ratios that are available and if I ever had the itch to put my power in the car it’s already setup.
I've not been active here in quite sometime but looks like another A is in my future.
Has anyone put a newer Tremec TKX in their A? I have one available to me and seems like it'd be even better than a T5.
What would it take to install it?
Thanks,
D. Hellstrom
After a minor hiccup with the rebuilt carb, the '31 is running very well. It seems that the carb was the major contributor to the Sedan's poor running. The carb ended up needing a throttle shaft and float valve. The drivability and idle quality has a very noticeable improvement.
I'd now...
First, thanks for the replies and ideas.
The tank actually looks very clean with no rust floating around. The carb has been sent to Renner's for a rebuild. I will also remove the original cast iron sediment filter along with glass bowl filter installed after it and put a glass bowl sediment...