Recent content by HotRod-1

Ref: Hard Times, Jim Brierley, midgetracer, mngreen Thanks everyone for all the outstanding info provided above. My Miller OHV head has an "A" cast into the left front top along with a smooth valve cover. Thus indicates my head is a 1930 or so early (Craney Gartz) Cragar.(Credit Hard...

Thanks Jim for the info. I'm a bit embarrassed on why I could not get the line provided by Dan Price to fit. I had the output line connected to the input port on the pump. But yes the output line exits the block through the fuel pump hole. By the way, your Brierley ground cam is installed...

I plan to use an external filter. Clean oil is nice stuff. I know I need to plumb a couple fittings into the gallery side cover. I just need to know how to get the oil from the pump to the exterior of the motor. Maybe I should review Jim Brierly's book again. Thank you for the leads. Post...

Hello, Not sure if my question is appropriate for this thread. But here goes. I want to install a new Dan Price oil pump in my model B engine but cannot figure the routing of the internal oil lines. The oil pump came with lines but no instructions. I was hoping someone might have a photo...