Recent content by hellmet

the 18 turtle I got came off a 47 banjo does that mean it has 3:54 gears in it?

how do you press the gear out ? got a 18 turtle and got new 17 gear.

how about a 47 rear end with a #18 speedo drive does it have 354 gears?

whats the differance in a 20 shell and 18. thanks

i had 411s now i have 325s the one i have now is a #20 i believe i need a #17 or so so my speedo will read right i also have 700 tires in rear. If anyone can help me on this one. thanks billy

for 158 bucks ill just get it. im not pulling it out again. can any link the instaltion of the bearing. thanks for all the help.

think i got it figured out my buddy gave me a hallibrand solid drive shaft same legnth as mine. my shaft is only 47 1/2 in long so i wont need the rear bearing . i think when i originaly cut mine down i never checked the rear bearing in the tube must have been bad plus my shaft was 11...

YES im going to use my cut down 40 tube .

I would love to see the the dick sparado set up Im just confused on what to do. bums me out to drive my car. I know the 33-34 set up is the way to go. just need to know hows its done to replicate it.

do I need the 33-34 torque tube also

what do i need to do this what adapter do i need

any truth in timing the splines after being cut?

im in hemet ca how much for the bearing

here my delema i have a 40 rear end and torqe tube. the bearing in the middle came apart as in the rubber around it came apart. it has been shortened to fit a 32 chassie i always have had a vibration since i built it. at speeds between 53-63 so ive heard they dont make the bearing with the...

any pics of how it should fit and look. thanks billy