Recent content by gwrskien

Can you use 1/8" thick wall sleeves, or do you need thicker walls if you onely have a good press fit on the top and bottom? It seems to me that the "wet" part of the cylinder would offer little support because of the crack. i think i can use same method on my block, so any info would be great...

Hello, on a other forum these guys bore out the whole cylinder and put in new thick sleeves with a shelve at the bootom for it to sit on..is this a possible way to go? I hope someone here says "yes i have done it" because i have a block with circular cracks just below the deck, 15-20mm down...

please send info to: gwrskien@hotmail.com looking for bodys/sheetmetal,titles thanks

please send detail to: gwrskien@hotmail.com looking for bodys / sheetmetal parts,titles thanks