Recent content by GJRoberts

Does anyone know of a source for Duchess Blue paint? My Body shop can't seem to find a source. Codes are Dupont GS733 and TCP IM 123.

I could find no online existence for Third Gen, other than a Facebook page that was last used over a year ago. Their WWW.thirdgenauto.com/ is a dead link. ???

What's an LB engine?

What is copper coat?

Doing some major repairs to my 1936 21 bolt Flathead. A simple fan blade failure resulted in a grenade like destruction of almost everything in sight. Fan, Radiator, distributor, coil, plug wiring, intake manifold, and alternator. On the plus side?, I also discovered head gasket issues while...

From the best I can surmise from the damage, a blade broke nearly in the exact mid point (about3 inches of the six inch length. The broken piece then bounced around in the engine compartment, bending another blade in a right angle at the mid point, making a donut shaped carve out of the...

It already is converted to a 6 volt alternator.

I would like to replace the factory fan and install a 6V fan on the radiator. The last fan broke, and cost hundreds in damage. 1. Should I mount it on engine side or outer side of the radiator? 2. Push or pull air on the optimum side? 3. What size fan should I get? 4. Can anyone recommend a...

After a broken fan took out my ignition distributor (into many pieces) and radiator, I ran into difficulties reconstructing the correct configuration for the spark plug wiring for the ignition. In replacing the distributor. I used the schematic as listed at this site...

Which of those last two numbers is the height?

Would that be a Group 1 12 volt battery then? I have been using an undersized 12 volt battery for the past 4 years with no issues.

What is the proper size of 12 volt battery to fit in the battery space on a 1924 touring. Either the Battery Group designation or the actual dimensions are needed for a replacement.

Was that recently? I've heard they have made some inroads in their quality control.

Unfortunately it doesn't have an original funnel radiator.

I have narrowed down my needed radiator replacement to either Bergs or Brassworks, Since I have an early 28 Phaeton, and Bergs doesn't make a funnel inlet, I'm leaning toward the Brassworks. However I have concerns relative Brassworks past quality control record. For those who have...