Recent content by Gary in MN

The seat bottom wood frame move around. Are the two brackets marked with a silver X secure the seat frame. They appear to be part of a hinge. [/IMG]

Years ago I ran a Rajo 4 valve and made an extension to lower the carb. About 6" long I was able to use gravity to supply fuel. The problem with lowering the carb is you no longer have warm intake air. Mine ran well for a short time and then the inside would frost up and close off the A/F...

Just a picture no info. Gary

I am installing a top wood kit that came with the car. I do not know who made the kit or how old it is. The problem I am having is with the header. Attached are three photos. One photo shows a gap between the metal header and the wood header. Is there a seal that fits in there ? The...

Btt

There are two panels, one is flat and one is curved. On this car pan head screws on the floor. counter sunk screws ( truss ) held the curved panel in. The two alignment washers are pictured. i hope the pictures help.

I have started to work on the trunk floor and the curved section at the back. Some one has torched two large holes in the curved section. Both items are available. My question is do they fit or should I just do a patch work repair. I am not going to install a rumble seat. Yes I...

A February 1929 chassis. Engine runs, and numbers match the frame. Two running board braces are missing a rivet. No generator or water pump. The rims are 17" from a 1933-34 Ford. Shift tower has a chipped corner ( I have the piece ). Something is going on in the rear axle, someone removed...

I have found a pair 1932 used Ford bumpers for a 1928 AV8 coupe project. Thanks Ford Barn. Gary

Custom body "A" ? Gary

A few pictures, there many versions of adapters of the KRW engine stand. Gary

I have sold 3 complete KRW engine stands in the last 4 years. Complete = cast iron base, upright, A & T adapter, notch plate, wing nut, and tray.They sold for $ 1700.00 to $ 2000.00 If you goggle Dan Price of Ohio, you will find a website where he sell reproduction KRW items. Hope this...

The head does not appear to be high comp. The head was in the pile of parts for a 1931 pickup project. Gary