Recent content by fuzes45

Hate to say, Macs had Zenith repros Bob

I use this on 12vhttps://www.amazon.com/Schumacher-SC1319-Automatic-Battery-Maintainer/dp/B0756Q88J5/ref=asc_df_B0756Q88J5?tag=bingshoppinga-20&linkCode=df0&hvadid=80745439395605&hvnetw=o&hvqmt=e&hvbmt=be&hvdev=c&hvlocint=&hvlocphy=&hvtargid=pla-4584345029241732&psc=1 and 6 v batt;s

Can use ATF and Acetone 50 -50 mix or Kroil Bob

Had difficult time with Ct Dmv, cleaned plate and painted, they said since i modified it could not get permission to use. Took paint off with stripper and tried Dmv office where it was ok to use before. I put two names on registration and wanted to get it on all documentation the same. If you...

Unless you are the lead dog the scenery never changes. Way up north author

Had same problem large puddle of oil , removed two shims from rear main brg, better. You could remove shims until you can no longer turn engine over then add one back. Do one at a time , about .006" each. Bob

Try FS Ignitions, may be able to help. I am running their ignition system. Bob

With only left you would be ready for NASCAR

Building transformers, dipped coil in Varnish and baked. Bob F

New ones made in China. Junk Bob

I had trans problems, replaced everything from pilot bearing back to u joint. Would jump out of gear down hill, could not up shift.Got two old units and replaced bearings but 2nd gear noisy but would stay in gear. Did get new shift tower still n/g. Looking back the new shift forks are crap. Did...

PU pick up a truck. Nice Dog

Location Marlborough, Ct Just west of center on Rt 66. Exit 13 off Rt 2 to Rt 66 Bob F

With spare on 30 Coupe needed to install bracket extensions, to clear tire. There are brackets that are thicker , so if a heavy load in trunk go for more robust ones. Bob F

Re: Brassworks ‘28 Show Quality vs Active Driver? Bought a Bergs radiator, installed a Vintage t housing with 160 degree stat runs cooler than original that was flushed and tested professionally. I would look int Bergs vs brassworks. Bob f