Recent content by freddybush

How do you put the snap ring on the main drive gear on T87 D 3 speed Borg warner transmission.

Hey guys, hope to get some help on installing the snap ring on the main drive gear. T87 D top loader 3 speed. Tried to send pic but unable.

Need hop 55 crown 292 2 bb runs great for 20 minutes then dies no starving for gas just dies then will start next then the sme

Hi all, changed out 12v generator to 3 wire alternator, I connected the wire from generator light to A terminal on voltage regulator to the alternator, Everything seems to work like it should, gen light go goes out when started alternator is charging all seems good but there is a drain on...

Thank you Rick, much appreciated

Anyone know the dimensions of the radiator support pad on the 55 crown? AD-8125-B

So Rick the sheet metal attaches to the front of the U support and the radiator attaches to the backside of the U support. The radiator does not slide into the U support?

Good point Ted I will do that. I will say when it is doing this I have put my camcorder down the throat of the carb to see if gas is still jetting and it is, but pulling the top off after it dies would be better i guess. Thank you

Also I have replaced the condenser twice, didn't help

Thanks Joe but I have bypassed both filter and fuel tank still did it.

thanks Ralph will do. Whats to warm?

yes same ballaster was used mallory. thanks

Deuce, I have the fuse block with resister are you saying that a resister can heat up and fail but when cools down it will work again. I have checked all connections but did not consider resister getting weak I thought it would either work or not.

Thank you but I do not have an electric fuel pump. When I checked the pump when it first did this the bolts around the top of the pump were not real tight and gas was around the edge. Sorry for the bad info.

No, I ran a line to the fuel pump from a bucket with gas and it still did it.