Recent content by freddie

If I push the sector shaft into the steering box the two copper bushes push up against each other. Machined a brass bush with smaller outer diameter as the copper bushes to keep them appart.

Thank you for your assistance. From a hot and sunny South Africa.

Good day all Is there any difference between these two instrument clusters?

Good day I am looking for a 40/41 3/4 or 1 ton truck Center hood strip. Can you please assist or direct me to someone that might have one? Much appreciated.

Thanks, appreciated.

No it is about a 1000 miles from my hometown. I do however try to get the waterfall hood ornament of the 40 1/2 ton truck. Also, I need a 90 number on my 40 1 ton truck hood ornament. They will check the number for me.

WoW, Check this!

I am restoring the above truck. Got a 1/2 ton hood center trim but it seems 1/2 the width of the 1 ton truck's center trim. I assume the 1 ton truck's is not reproduced and I will have to look for a good used one?

WoW, did not realise that there is still so many of these trucks still out there. Thanks for sharing your information with me.

Thanks

Thanks

I think this brass carburator is from a model A. Is it worth something?

Thank you for the information. I was under the impression that the 40 and 41 had the same grill trim. I have a 40 with the narrow hood ornament. So I would have to rephrase my question: do the 40 1 ton truck perhaps share the center grill yrim with any other models?

Is the grill center piece trim on the 40/41, 1 Ton trucks perhaps similar to any other models?

Cooper Stewart was a London based factory that built speedo's and clocks for virtually every make of car and motorcycles.