Recent content by fotfod

conrad restomods was coined by barrett jackson because they didn`t know there was already names like hot rod, street rod, restoRod because they dont bother to read rod mags and their ignorance is deplorable but when novices watch that show they think that is the proper terminolgy. i have...

i too have been following this thread and the ones before. i talked too paul bradly at hershey and found that he was ignorant condesending arrogant and i cannot understand why anybody wouid say he is a nice guy and reccomend his products to anyone unless you want to cut them up to repair a...

your friend is right they are junk. carpenters are not much better. drakes are the best by far and most accurate.

i should hope not. sound deadner would look awful on the outside of the door but i have seen worse. lol

the top is puffed up with foam instead of cotton we call it puffed top syndrome. a simple mistake that a lot of restorers and upholstery shops make.

i have a 32 r.p. cowl. it has no holes it is not shorter in that area. it is for sale

depends what country you were in canada and commonwealth countrys in 39. us in almost 42. i am not sure about the commonweaths of maine mass. penn. conn. i guess they still belong to brittain. lol but you easterners knew that. seriously canada being the major export factory shipped all kinds of...

i 2nd that motion

the tudor door bottom will probably fit as they are same length but are quite different. on convert where bottom meets door panel face. it is higher and has embossing for strength. they were produced about 15 yrs ago but were a terrible fit i have made about 4 sets that were accurate and...

t rubber

no. different shape and curve. bolt spacing where fender filler piece bolts on frame at r board is easiest way to tell at swap meets if you cannot compare. take bolt spacing off 32 & 33-34 frames

tool tray for a sedan is longer than a coupe- conv. i do not believe anyone makes the sedan one. drake makes the right one for a coupe.