Recent content by fordmerc

Thank you all for all good advice. Rolf in Sweden

Hi Fordfriends. Does anyone know if it`s possible to replace the oiltube that provides oilpressure to the camshaft bearings on flathead 8BA engines? I have a good block with a bad oilpipe and a cracked block with a good pipe. Thanks. Rolf in Sweden.

Re: ´36 5 w Thank you Ford barners for all helpfull answers. Rolf.

´36 5 w Hi Ford barners. I am working on a ´36 5W coupe. In each end of the windshield opening there are two small holes.On inside there are two pipes where the holes are.On one of the pipes there are remaines of a rubber hose.Is this a drain hose?Wher does it drain?Can´t find any holes on the...

WTB ´28 ´29 roadster wind shield frame Hi friends.Visiting Florida for Turkey Run in nov. Looking for a ´28 roadster wind shield frame.Have stantions. Live in Sweden. Thanks Rolf

´36 wiering Hi Barners.Building a wiering system for my ´36 5 W. Do i use 14 guage or 12 guage wires?Or maby different on different places? Adding a turn signal to my car.Will keep 6 V and pos. ground. Thanks. Rolf in Sweden.

Re: ´28 vs ´29 Thank you all for thees helpfull infos. Rolf

´28 vs ´29 Hi,Barners.I have recently bought a ´28 (´29) roadster on ´32 rails.(project) Have found aftermarket top irons that fit ´29 to ´32.but not ´28.How do i tell if my body is a ´28 or a ´29?The titel is ´32 so that is no help.Hope someone can help out. Thanks. Rolf in Sweden.

ford ´32 early pass side motor mount Hi barners.Is there any value in one motor mount for a early Ford ´32? Have the pass.side motor mount. Thanks. Rolf in Sweden.

´34 two door sedan WTB.Ford ´34 two door sedan seats.I live in Sweden but have a shipper in Compton CA,that will help to ship from US to Sweden.Thank you.

´36 doorhinges Hi Fordbarners.Still looking for doorhinges to my ´36 5w.Upper pass.side. Please help me where to look or who to call. Thank you. Rolf in Sweden.

wtb ´36 doorhinges Hi friends.Need upper doorhing,post side,or compleet unit to my ´36 5w coup. Live in Sweden.Have paypal. Thanks.

thanks,it was helpfull

Is it posseble to replace the seal in the front(narrow)end of a torktube with a bearing in the middle,without remove the bearing.???If not,how do i remove it and put it back without destroing it? Thanks from Rolf in Sweden.