Recent content by fordfixer

Just wondering what people are using for cotter pins inside the engine. I have another car in the shop for connecting rod failure, do to failed cotter pins. Everything I can find is made in China.

Thanks for the help.

Pics of head in question. Hoping this works. I previewed the message and it showed the pics. But going back to post the does not show pictures just these numbers.

How to upload and post picture in a thread.

I just purchased parts from a fellow model A enthusiast. Amongst the assorted parts was a new aluminum head. It has no markings on it. Just wondering who made these, besides Winfield. Also how would one determine the compression ratio? This was from his estate.

Hopefully these are the pics of the parts. Need correct sequence of parts. Does this housing have grease zerk like the A? If not does it have a specific way to be mounted?

Thanks I’ll give it a go

How does one post pictures her?

How to post pictures here?

I think you posted wrong.

Working with a museum in another state that is trying to put an AA trans. back together. Their question is how the rear bearing retainer parts are assembled. Was wondering which way the inner plate is installed. Any pictures available? Thanks for any help.

Again thanks for the info.

Will the AA TRANS mount up to the BB BELL HOUSING? Just wondering if we can inter-change them.

Can you please contact me at lisotajon1@icloud.com The museum is interested in your offer. Thank you.

Can you text me at lisotajon1@icloud.com The museum is very interested in your offer.