Recent content by Flysafe

Thank you so much Ronnie by the notice and the photos too. As I don't know of any existing engine near me not always it is clear, my support it is photos that I found in my searches or some help from the members of the forum. Now i believe that is correct, the left that i have, the right it is...

So it is only the diretion of the teeth gears correct, I need flip over the both gears teeth? Thank you so much by the notice. JOrge

What are the components that are not correct?

Hello all, This part gave some work, now do the rest of the holes.

In progress :)

Thank you JSeery.

Thank you so much for the photos JSeery, have the same lines and holes, that I have been drawing. If is possible yet, can you take a close-up of the areas that I marked? Thank you very much. All the best, Jorge

Thank you so much JSeery

Hello all, I 'm working in the front end of the block, I will need some help, someone have any photos where I can see the front end of the block 59 AB without the water pumps and the distributor cover? I already made a google search but not find anything. Thank you so much for the help. All...

Hello all, The 59 AB block have the yellow line that I made? The block 8 BA have this fill. Thank you so much.

Hello all, Exhaust channels done, and e few holes. Start the front end of the block.

Some progress in the design.

Hello all, Some of the lines after extruder.

Thanks.

Earlier I do this type of piston, can be used in this engine model?