Recent content by flybob08

I wouldn't be so harsh. The price of the wrench is not bad and remember we need suppliers willing to serve the Model A community. I have found Snyders to be very accommodating and helpful!

Try the coil resistor - it may be shorting

I have reinstalled my starter but for the life of me can't remember the order items are installed on the electrical post between the wires and washers and can't tell from pictures if the (a) battery line goes on first or last or whether the fuse block wire goes on first or last and (b) where the...

Be sure to Use the yellow petroleum tape. They have it at Home Depot

I feel fairly stupid posting this question - BUT - I had my steering column rebuilt and received the oil seal retainer nut with a tube and a felt oil seal, but for the life of me I can't figure out how to install this. If I insert the felt, there is no room to thread on the oil seal retaining...

The problem using a straight edge on the bottom is all of the bolt protrusions and the cross shafts. Will try the laser and see if that works. It may not be a precise enough dot, however

How should I measure to see if I have frame sag as opposed to the body blocks being incorrect and causing door alignment issues? Can I use a laser line and measure at various points? Thanks

Best wishes for a fast and complete recovery- prayers are with you and your family

Where and how do the floor mat studs (photo attached) get installed. I did not see holes in the floor for them. I do have a few studs on the floor and lower firewall, although the studs don’t seem appropriate for my ‘28 roadster pickup Thanks

Here is what I have -

Spring hole is centered. New bolt coming Tuesday

Is it possible that the front axle is off center? When I set a plumb bob down from the center of the crankshaft to the axle, the mark is not on the center of the axle. The mark is, depending on how I measure, about .5 - .75" from the center of the axle. If that is the case, how do I recenter the...

Snyders can rebuild for you. It will take about a month. Bob

New nuts and cotter pins are mounted. Came in the mail today from Bert’s

Can’t imagine it is the dog one as it is sitting on the two balls fully seated and centered