Recent content by flatheadron

Rear fender skirts for a shoebox Ford, 1949-1951. All steel, aftermarket skirts(no name on parts), Nice shape, no dents, rust, or scratches. Outside is painted maroon, backside is red oxide primer. Latches work well. Can ship, but size and weight may make shipping pricey.

One stainless-steel steering arm. !-3/4" drop, threaded female holes are 1/2'-20 thread, 3-5/16" apart, 7-degree tapered hole for tie rod end. has a stainless-steel tie rod that has a 9/16"-18 thread. Would ship USPS small Flat Rate box at $10.20.

Sold

sold

Sold

Stewart Warner Tachometer # 82170. 0-8000 RPM, 3-3/8" diameter, electrical, analog, black face, stainless bezel, instruction sheet. Never used, installed only for mockup purposes. Buyer pays shipping.

Stewart Warner Deluxe Series Tachometer #82162B. 0-6000 RPM, 3-3/8" diameter, 270-degree sweep, 12v, black face, white numbers, stainless bezel, light, wiring, and instructions included. Electronic, programable. Will work on 4-, 6-, or 8-cylinder engines. Was in service about 5 years, worked...

Stewart Warner Deluxe Series speedometer #82896. Electronic, programable, 3-3/8" diameter, odometer, black face, white numbers, light, wiring, and instructions. In service for about 5 years, worked great. buyer pays shipping.

Need a set of rear bumper brackets for a 1964/1965 Falcon Ranchero or station wagon. There should be two brackets on each side fastened together. Standard sedan/hardtop/convertible brackets will not fit.

Thanks to those who responded. Just was not sure as the older distributor had a tiny hole for oil to the wick. Mine just had an expansion plug, not slotted like these are. I cleaned out the inside of the shaft and the wick, will re-oil and get a small 3/8" expansion plug to close the hole...

Anyone got a 42-48 Ford distributor around that they can take a look at the back side of the unit that faces the cam gear. Between the two drive lugs is a core (expansion) plug those seals off the end of the shaft. Inside the shaft is a lubrication wick and the other end of the shaft has a...

Found one, thanks again Ford Barn, you guys always come through for me.

Looking for a usable oil bath air cleaner for my '50 Ford V8. Most important that the element is in good shape and cleanable. Paint condition and small dents ok. send pictures and price.

Book sold. Thanks again to The Ford Barn for helping us all out.

BTT, Better and half the price of one from one of the suppliers.