Recent content by farmerjohn39

Part Number: 1910 Polished Stainless Steel Cover for Spare Tire x 2 Please advise if you have the pair available. Thank you all. John

Hi BillCNC In the last week I purchased a NEW " Air Balanced Carburetor" from Synders, just so I could install a air filter on the carburetor' and I have nothing nothing but problems with the new carburetor. The first one Synders sent me leaked gas through the casting ( I think it was a pin hole...

I have a 1930 Tudor sedan, my winter project was to have the steering column rebuilt. I just finished installing the column, along with all new tie rod and pitman rod springs & cups. My car has a steering stabilizer on it, my questions is now that I have everything rebuilt do I need the...

I replaced the brake lining on all four wheels over the winter, I used the break lining kit from Snyders p/n A-2021. When I took the car out this spring everything was just fine, good braking, no wheel pull, all the drums were not exceptionally hot after the test drive, all was good. Now that I...

When installing a (new) recondition steering arm on the left side of the front axle, this is the one with the two balls welded on p/n A-3131 from Synders, I noticed that there was a grease fitting where the steering arm slides into the front spindle, this would indicate to me that this arm...

Thanks for the feedback, I used Westleys and a stiff brush and let it soak but took forever.

Anyone have a reccomendation for removal of the blue coating on wide whites. I've tried westleys and green scotch brite. It's working but slow.

test

test