Recent content by engineman

  1. E

    Drain plug ID

    Have a 59AB engine with a drain plun gasket dripping. I do not want to remove it without a new gasket The hex head requires a 2 inch socket. Any help as to where I can purchase a new gasket would be appreciated. Thanks
  2. E

    1938 Ford Std right front fender

    This fender is ready for your color paint and install. More pics if you are interested. $275. plus actual shipping cost.
  3. E

    Holley 94 Model 59 Carburetor

    Nice running Holley. I upgraded to Offy intake and Edelbrock 4 brrl. Carb started and ran good. No hesitation. $40. plus actual shipping co Sold. Thank you Fordbarn.
  4. E

    1938 Ford Std RF fender no rust

    This right front fender has no rust and is ready for your color of paint. I am located in the southwest corner of N.H. just outside of Keene. $300.
  5. E

    1940 ford gas tank gallons

    I have a 40 tank from a 4 door sedan that isn't to bad from what I can tell by looking inside with a light. I am in Gilsum NH
  6. E

    8BA intake on a 59A

    I just replaced a stock intake manifold with a new Offenhauser #1079 on a 59AB. The casting must be universal for the 8BA as well. Location is there for the vent to be machined. The stock fuel pump lays right on an intake runner. I carefully ground for clearance and used two fuel pump stand...
  7. E

    At the end of the rope with my 46.

    Also, make sure you have the correct polarity for the coil. 6 volt positive ground + from coil to distributor. Don't give up you will get it. Good luck
See more
Back
Top