Recent content by eberhama

Keep in mind the '60 wheel is dished and the '53 is not. So using the 60 wheel on the 53 column will put the wheel a couple inches closer to your chest/stomach.

The bolt things are for an under bed spare tire carrier. Not sure how year specific they are, but they look like the ones under my 56 f100.

Hot air heater set up removed from a '40 ford. What you see is what I have. Floor vent flaps move, Defrost/Heater knobs do not. $25 to ship in the US. thanks, Matt

Southwind gas heater, removed from a '40 ford. It is untested,what you see is what I have. $15 to ship in the US

It is a wild @ss guess, not to be confused for a SWAG, a scientific wild @ss guess.

Got it, thanks ford barn!

Selling parts off this flathead and ******. $20 for you name it. Block is shot, but anything else I can yank off of it is up for grabs. Generator is stuck, starter case is rotted, water pumps are stuck. ****** had water inside but isn't super rusty. 1 head is junk. Distributer spins. If its...

This one's going to be a 40 ford coupe. It will prob end up with an sbf, I just wanted the old guys to choke on their coffee for a minute. The sprayer part of it was long gone when i got there. I did get the drivers head off, similar carnage there.

That would be quite a save here in the states, but to do it in Africa?? Hats off to you!

This ones getting a 4bt cummins. The '36 3 window is getting the 5.3 chevy motor.

The rolling frame is going under a 40 coupe. I just need the flathead out of the way. I'd like to get it to someone who could use the bits and pieces, but after a month on craigslist, I cant get anyone to come and haul it off except for the scrappers. I barely have room for the old car stuff I...

That's just a shadow. I did take the pass. head off. The #1 has the cylinder wall pushed open. #4 the piston turned to powder enough that I can see through it. The vally is really clean(comparatively) though.

I bought a '36 ford that was cut into a crop sprayer back in the fifties. In it, was this 24 stud flatty, and the original 36 ******. The motor was a dealer replacement marked 05/60. The block is junk. The water pumps, generator, and pretty much everything else are locked up. I got the shifter...

Looking for some panel stuff. Really need some rear door hinges. I just need two body side pieces, but I will take what I can get. Could also use a rear tailpan, and a pair of running boards would be awesome. It also looks like I will end up with a near complete set of rear door hardware and...

Looking for a set of rear door hinges for a '53-'56 F100 panel truck. Not sure if earlier or later hinges will work. May also consider a set of junk rear doors to get the hinges or to use as patterns. Will also consider a set of nice rear doors if they're super-duper cheap. Thanks Matt...