Recent content by Easy

Have the Stipe combination head puller/engine lift adapter ,works good.

Is your crankshaft counter balanced? If not I don’t know if you would want to take weight off the flywheel.

Last I knew the head gasket of choice for the Brumfield head is the Felpro 7013 revision 4. I had a head gasket failure about 5 years ago and replaced it with the Felpro, good so far. Got the gasket from Brattons.

The Model A Ford, returning petroleum products to the earth for almost a century!

What is the recommended pressure to run in the 19 inch American Classic radials?

Tubes for radials also. From Coker.

Just ordered new American Classic radial tires from Coker for my 1930 Tudor. Any pro or con thoughts using radials on the Model A?

Just ordered new American Classic radial tires from Coker for my 1930 Tudor. Any pro or con thoughts using radials on the Model A?

Am I the only one hearing a knock in that engine?

Concerning how the kingpin holes can get enlarged: It can start to happen after kingpin spindle jobs when the taper pin is inserted and tightened with a wrench instead of hammered in and then tightened. This can cause a loose fit between the kingpin and axle. After a while the kingpin will rock...

My camber came out on the money. I did have the same concern about the 7 degree camber using the hammer method. I was careful to beat an equal amount on the top and bottom bosses. The small amount of actual movement to tighten the holes makes it unlikely you would have a significant change in...

I just went through the same axle situation. My axle kingpin holes were very sloppy. After talking with several model A club members they recommended beating the ends of the axle with a shop hammer to slightly tighten the holes. They had seen this numerous times and this process worked. The...