Recent content by E.PREUSS

Looking for a decklid... Any condition considered.... Thanks

Just looking at your placement of axle compared to grill , I'm going to try a few. Inches lower just curious where the tie rod lands in relation to the frame or I may have to do a clearance bump or just z the frame to gain the clearance... I will sort it out on Moch up but it's nice to see...

I think you should still be able to fish the horn rod through the cover ? Then you need the 2 bolt clip that attaches the switch

I need to pull the heads off my big 59a with offenhauser heads , a friend was over and asked why I used the copper gaskets... I really didnt have an answer other than I used to work for an old flathead guy and that's what we used... Copper coat and copper gaskets I guess my question is ... Is...

...

Pulled off of a rebuilt 312 that swallowed water and had to scrap Questions? Call/text 651-336-0522

And

...

Picc2

Pulled these off a 312 I scrapped one has a casting # edb-9430-a i believe is thunderbird and the other does not... The one that does not have #s also has a repaired ear that was broken ( amateur job) ... Any questions call/text 651-336-o522 thanks

Thanks for all the imput guys .. .. That's a NICE little 32 truck Gavin...I like it... Thinking about doing front suspension in similar fashion , with a dropped axle on mine... Could I get pics of the back where the frame rail and tierod are and a rough measurement if you have a chance? Is...

Yes , I'm sure there was, I was just curious what one could expect from a "small flat motor" , I'm not well versed in all things flat but , but have experianced those two bigger flat motors a semi stock 8ba a wore out 59a and a 4-71 blown 59a ( favorite one!) All in light roadsters...

Sounds good Walt ... I was thinking a 4" merc crank , some port work and maybe a 400jr cam or equivalent ? I actually found a post on the hamb saying the LB blocks won't take too much bore... I wonder why the castings are so thick on the later motor and not early?

Hey guys , I tried to do a search but couldn't get it to work... I have had a couple later hotrod flat motors one was a 53 merc bored 3 5/16 with mild port and 400 jr. And the other is a 3 3/8x 4 1/8 ported with a 3/8 potvin ... A couple others just stock Anyway more of a curiousity but how...

Sold