Recent content by Drive Shaft Dave

I use Tom Wesenberg voltage reg, his is fool proof ,if the generator should go open circuit the voltage will remain low, not going into a self destruct high voltage runaway.

Color looks good to me.:)

She can't wait to get back in that coupe.:D

Very interesting term, I had not heard that panel call the tulip panel before.:)

United Engine &Machine,Sil -Vo-Lite pistons,

Looks like the spring on the bottom the oil pump is broken.

Drive a modern car.

looks good on paper, let us know the outcome.

Dont forget to use a thin flat washer under the shaft nut.

The idea is to break the spot welds there are usually two.

This is one of those times when a block of wood and a very large whammer is your friend I had one stuck so tight that i had to take out the three bolts , then...

Yes, if you are pushing the clutch pedal to the floor it will spin. how close is the throw out bearing when the pedal is released?

In the case of the ModelA,the revised rear brakes came with a stepped drum to accomodate the emergency brake band. The early models simply picked up the service brake with the hand brake lever. As for the 32 maybe some one left them off.

I just remove one of the bolts.

The same part is used for both configurations.