Recent content by dgmgohl

The motor was out of a later model Ford truck.

I have a 1956 Customline with a transplant 292 single barrel. It was running rough before storage, and I was adjusting the set screws in back. I turned them all the way in to adjust, and the motor kept running. I know this is not normal. What would cause this? And is there an adjustment I'm...

Found the problem. A friend suggested that I take a rubber mallet and tap lightly on the distributor shaft. That did the trick. Now loose, I can set timing. Engine was just re-built, for some reason the HEI was stuck.

yes, I know where it should be set. But the HEI distributor doesn't move when the car is running. That's the part I'm having a problem with.

https://mail.google.com/mail/u/0/#inbox/QgrcJHsTgFwCQJLVKbKdckdVdClGgGVJBnb?projector=1&messagePartId=0.1 The only number I could find on the unit was W1218. Hopefully this url will work for a photo.

I'm not sure about that. After loosening the plate that holds it in place, the car running, the distributor will not move like the old originals.

I just got back my 352 from being rebuilt. It's in a 1965 full size Custom. My question is, since I haven't worked with a HEI before, is the timing setting suppose to be set right at TDC? That's where its set now. It was easy enough on older distributors to turn them when setting the timing. I...

Hi Dave, thanks for all the help. I already have the choke cable in place, I just need to get that cable housing piece for the carb. A friend of mine who works with a lot of carbs thinks he has a couple. I'll plug that tube you were talking about and observe the crimping tube and fix. I'm...

https://www.fordbarn.com/attachments/522694/ https://www.fordbarn.com/attachments/522695/

https://www.fordbarn.com/attachments/522694/

https://www.fordbarn.com/attachments/522694/ https://www.fordbarn.com/attachments/522695/

Thanks, put a new one in, only goes up to 4.

If I did this right, 2 photos of my current carb. As I mentioned, this 292 came out of Ford truck. Previous owner didn't know the year.

I think so. The carb says "Ford" on it.

Just purchased a 56 Ford with a transplant 292 Y block. Electronic fuel pump. On cold start the engine fires right up. But on a warm/hot restart it barely starts. I have a single barrel Ford carb on it. Manual choke not connected because there's no clamp to fasten the cable shell. Any suggestions?