Recent content by Derek1937

I’m looking for a new old stock set of door latch mechanisms for my 1937 ford pickup if you have anything let me know at my email. Thanks dereklefsrud1@gmail.com Cell: 587-256-0464

I have one new old stock 1935 ford pickup brake drum they don’t re make these and are one year only so very rare and hard to get a new one Call or text for pictures 587-256-0464 dereklefsrud1@gmail.com

I have a new never used model t true fire ignition never have to worry about them coil boxes again with this set up. Call or text for pictures 587-256-0464 dereklefsrud1@gmail.com

1- model a distributor that’s new 150$ 2- new zenith carbs never been on a car 600$ each 2- used but good working starters 75$ 1- used but good working generator 100$ I’m always open to negotiating so let me know will send pictures if you call or text 587-256-0464 dereklefsrud1@gmail.com

I have probably the best set of front fenders for a 1927 model t has only a couple 2” dints in them and zero rust 600$ for the set. Call or text for pictures 587-256-0464 dereklefsrud1@gmail.com

1952 mercury engine 4” crank I have a complete 1952 mercury engine with a 4” crank block is stripped right down and is .10 over on the bores and crank is .05 on the mains and rods. Call or text for pictures. 587-256-0464 Email. Dereklefsrud1@gmail.com

I have a 100% rebuilt model an engine ready to ship block was hot tanked pressure tested and crack checked and fully machined has H&H touring cam adjustable lifters modern valves aluminum cam gear new crank gear .125 over piston rings balanced and ground flywheel fresh just poured and machined...

I have a completely rebuilt 1930 model an engine has new Babbitt rods and mains cam and timing gears adjustable lifters straight stem modern valves .125 over pistons new oil pump. leak less water pump distributor starter generator exhaust manifold carb and distributor all come on it also. Was...

4” mercury crank I have a 4” mercury crank would like to get 500$ Canadian for it or I have block with all the parts also for it that is .030 over I’d sell all in one for 1000$ Canadian. Email dereklefsrud1@gmail.com Call or text 587-256-0464. Thanks

4” mercury crank I have a 4” mercury crank don’t know how to post pictures on here so email me at dereklefsrud1@gmail.com That’s 500$ Canadian Thanks

I’m looking for 5 sleeves for a 1940 v8 60hp any help finding them would be greatly appreciated thanks you can email me or call/text Dereklefsrud1@gmail.com 587-256-0464

I have a set of model b kr Wilson oil grove cutters. I don’t know how to post pictures on here of them but you can email me or text me. 3250 Thanks dereklefsrud1@gmail.com 587-256-0464

I have about 15 sets or nos ford rod bearings that are .020 ford part number is C09TS-6211 M.they are 250 a set or can make package deals for less. I have probably over 200 rod bearings and main bearings for the flathead v8’s except the 60hp. Email me or text me for any specific bearings...

Looking to buy a 1940 v8 60hp starter and fuel pump. Thanks Dereklefsrud1@gmail.com

I am looking for a set of 1940 b8 60hp main bearings that are 20 under size the original ford part number is 92-A-6333-E for the front and center and the rear is 92-A-6331-H. Thanks dereklefsrud1@gmail.com 587-256-0464