Recent content by DENNIS MCNAMARA

I have used a six point deep 3/8 socket 1/4 drive with success. Also my wrench of choice for 50 plus years is a K/D offset box wrench 1/8 on one side and 3/8 on the other. This tool was design for use on wheel cylinder. I did like and will try some of the other suggestion as I always get good...

i am sure the Ford Barn has its reasons for not allowing new members to PM, but if that the cast when I did try and sent a message does the staff forward my PM ?

I was not allow to PM because I have not had a least 10 postings. I did try and was not allow but did get a message why i was not allow. i don't how to reach out about the price and how to order the 57 1 1/2 master cylinder

More information that might help other down the road the 1 1/2 inch bolt pattern has a Ford casting numberAJ2155A and is a FOMOCO MASTER. OTHER MARKINGS 1 INCH BORE R1 and F DATED 9-27

As a first time user on the Ford Barn thanks for all the input. After being told by NAPA and others that the master cylinder they had was correct and they was no other listing for my car I now know I was right. The post by Mobile parts was spot on. Many thanks. i have a 1 inch rebuild kitnow but...

Any help in finding the correct master cylinder for a 57 Fairlane. Ever unit i have purchased on review on line will not match the bolt holes on the firewall. All units were to fit the 57 Fairlane. Any unit with the 18000 series will not match bolt location spacing on the firewall. ANY HELP...