Recent content by dbknorr

Thanks to all for your comments. Sounds like my situation is not unusual but I need to seal the bolt holes. Again thanks to all in a great hobby.

My differential is leaking badly on the driver's side. When installing the radius rods, the driver's side rod was about 1/4" short of the bolt holes on the axle housing. With much difficulty using a crude screw jack, I managed to get the bolts in. Now that axle housing leaks, I presume...

I need a pattern to make the wood side arm rests for the back seat of my 31 Slant Windshield Town Sedan. Original wood pieces would be good too. Dan Knorr 575-937-4758.

Need a Dash Rail for 31 Slant Windshield. Can trade another rail or buy outright. Dan Knorr dbknorr@zianet.com 575-937-4758

I need the robe rope for a 31 SW Town Sedan. I have the brackets but need the rope.

Still looking for the robe cord brackets to fit Slant Windshield 4 door Town Sedan.

Need two robe cord brackets for Slant Windshield Town Sedan (160B). This is the AB bracket shown in Judging Standards p. 12-10. Also need two inner rings for 30,31 headlights. Need 10 escutcheons for 160B Slant Windshield Town sedan.

Still looking for a dome light for 31 Slant Windshield Town Sedan. It is the plain oval.

I need a Trico vacuum windshield wiper assembly with the extended shaft for a Slant Windshield Town Sedan. Also need an Oval Dome Lamp assembly A-13776-0 for the same car.

I checked Classic Wood today and they said they don’t make the rear seat cushion or back rest wood.

Cape Codder - thanks for the response and offer to measure but I am pretty sure the wood on a SW 4dr is different than a Tudor. Thanks again.

It is my understanding that all Slant Windshield Town Sedans are 1931 and were built to a Ford design. Bodies were built by Murray, Briggs and Ford but all would be essentially the same. Let me know if this is incorrect.

I need to buy or build the rear seat cushion and backrest wood for a SW Town Sedan. Have not found a source but could use plans to build. Any information appreciated.

Thanks for the tip. I try it.

I have removed the rope like material that is used for a tack strip above the doors of a SW 4 door. There are two parallel troughs above the doors with tabs every 4 inches or so to hold the rope material in. What material is available as a replacement? Would appreciate any comments.