Recent content by davidGR

Sorry guys, 1930 Town Sedan Sent from my iPhone using Tapatalk

Hello everyone with winter here I’m finally getting around to rebuilding a my windshield wiper. My car never had a wiper on it and the po bondo over it, I’d like to put it back on. The wiper I’m rebuilding doesn’t have any pitting in the bottom FYI. And no I don’t want to just cost my window in...

Anyone know where I can find the curved Otwell Door for my Model A? Best to look at swap meets? Thoughts.

I’m looking to buy one for a rebuild what do you got?

Looking for a vacuum wiper motor to rebuild. Let me know if you have anything.

Hey guys, So I'm about to install some Armstrong shocks on my Model A Town Sedan. Funny enough I actually sold my old MGB for scrape 3 months before I bought my Model A lol. Had I know I would have scavenged the shocks from it before I got rid of it. I have searched all the post on the...

Hey guys, I'm looking for some hardware for my trunk. I need the corner the chrome corner pieces. I have one of them just not the right side. Does anyone have some of them laying around? Thanks

Hey everybody, Has anyone tried out BA15d LED headlight bulbs from Classic Dynamo? Did you like them? Did they fit in your headlights? Plug and Play? Any pictures? I'm running a 6v Positive Ground car with typical dual filament bulbs. Like the idea of a brighter bulb with less power...

Hey guys I bought a Union Pacific 5007R turn signalswitch for my car and noticed on the bottom of the diagram it says for negative ground cars... I completely forgot to check that, is there anyway to make that switch work on a positive ground car? Sent from my iPhone using Tapatalk

Update: Got it home running the Gav 3/4 turn out, stayed at 190. Took the radiator off and flushed and let it sit with CLR and vinegar. My baffle is gone so I can see the tubes going down and I fished some wire down a couple and there all plugged. It’s off the shop into that is known for...

Hey guys, Radiators off to the shop to be rerodded so I took the water pump to see what the inside of the water jackets etc looked like. Here are some photos on a scale of 1-10 how bad does the inside look? I was thinking of capping the bottom inlet and filling it with something like...

Just installed a new Amco temp gauge from Synders on my car with the goose neck adapter. I drove some co workers up to a lunch spot a few miles away, and my gauge is in the middle of the steam side. Little worried to drive it back until it cools a lot more, how hot can these engines get...

Morning guys, I need some advice, I'm in the process of adding turn signals to my Model A before the big metro cruise is Grand Rapids this weekend, I'm using the Union Pacific switch I got off Ebay here 1. I have to do anything different or backwards for this switch since my car is positive...

I'm looking for working oval 1930 Model A Speedometer, anyone got one out there they want to sell?

That’s looks like it should t have an issue fitting, can you send some closer photos of how it mounts? Thanks! Sent from my iPhone using Tapatalk