Recent content by Davew

I went to the local NAPA store and they made me one.. any size I wanted

I’m in.

Just for the sake of knowledge for me and discussion. The armored cable wouldn't be needed so couldn't a waterproof connector be used on the red wire going into the dist? That way it could easily be disconnected if needed. Just wondering..Thanks.

I've been thinking of this for awhile and as far as i know there are no dropped spindles. You would have to do a reversed eye spring and take out a couple leaves or dropped axle. A 32 through 35 or 6 will give you the same as a 2 inch dropped axle. If you stay with mechanical brakes you can use...

I’m looking for a good operating Heinze wiper. Thanks, David

I really enjoyed this. Thanks

I'll check third generation and see what they say. I don't know who Joe's is. Thanks for the help

Does anyone know where i can get a B dist rebuilt? I don't think Renners is doing it anymore.. thanks dave

Thanks for the help. Was wondering what that arm was for

I have a B distributor and would appreciate some help in wiring it up. There is all kinds of information on timing but can’t find a picture of where the ignition switch wire goes. Thanks

Wanted Model B timing cover I found one thanks

I just did this. Really stuck. Kroil, Heat, big hammer. Took three days but finally out. Perches are not reusable

I was looking at the garage journal page and read about single post lifts. Anyone use these? https://www.redmount.ie/single-post-vehicle-lift#

Mine is the top of the drivers side front window.. I have tried tape, and grease nothing works. Also leaks a little water. The back tray on my coupe vibrates where it meets the metal part. really annoying. Guess thats part of what makes them interesting.

Tom, what would the support brackets look like? Would they go over the existing tab?