Recent content by daren007

The planetary gears at the wheel would have to be tossed to make this work.

Toss the board. Adjust as you would a later hydraulic system. Then drive and adjust. Not hard to do.

First off toss the board. Once everything is in proper working order drive and adjust as necessary.

Re: OK, ... I'm Stuped * Solved * Backfiring out the tail pipe? Backfiring from the carb lean mixture. “After firing” out the tail pipe ignition.

Installed a “O” ring many rears ago and serviced with 600 oil. No leaks.

I would push it over a cliff.

Not Chang oil at 500 miles

I have been rubbing a Tillotson for years without problems.

Why reinvent the wheel. The 6volt system works just fine.

Just hold the. Hi/low pedal in neutral and move the parking brake forward. Then start driving it.

Was not aware of a rear main seal.. job weld will not work.

So you are saying the machine that removes the holes is paid $21.00/hr.

If you buy a policy they will not be around when you need them.

Terry is a great person to work with.

If you insist on using the bee hive setup use tubular shock bushings.