Recent content by cobra5laddict

Still searching. Thanks all

**update** im looking for a top shift trans not side shift / column shift The one i have in my truck now has been around the block. i rebuilt it a while back but its time to find something a bit better. the case i have was broke and welded at some point in its life, it pops out of second...

l'm new to this era so i'm here to learn. I had a 28 roadster with a flathead and sold it. I have 2 kids and really missed having them with me to cruise around. im toying with the idea of a 4 seater convertible 32-40. Ideally i'd prefer a 2 door car convertible that seats 4. Would that be a...

Sold sold sold

i just did this on my 28. below is a thread on the HAMB with photos of how things go together. https://www.jalopyjournal.com/forum/threads/roadster-door-dilemma.1143035/#post-13018232

FYI I’m working on a 1940 rear BTW

I’m on the home stretch of my banjo rebuild and everything is going together very well and smooth. My backlash is set and I have my gasket combination figured out. When I pull things back apart to apply some Indian head to the gaskets / housings how much will the sealant effect my tolerances...

is it similar to front wheel bearings? my banjo housing has grease Zerks on the hub is this typical for all years?

I pulled the bearings from the carrier and the races from the bells. It turns out that the carrier bearings are early banjo 18-4221 original ford stamped. The races are new bearing size. The part number on the race is timken 25522. Obviously a mis-match. Here is what I know now. I have a v8...

I have photos but I can’t seem to get them loaded from my mobile device. My guess is that it was slapped together but not ran.... like I said I drove it once (didn’t notice the side to side play beforehand) before I pulled it and took it apart. Suppressing how everything inside looks good. Gears...

Yes. Sorry, backlash not preload

I’ve been studying the rebuild guide and some website references and have a pretty general idea. I get the shimming on the bells to change the preload. The issue with mine is less of the minute adjustment of shimming / gaskets at the bells. The entire carrier and axles move 3/8” into and away...

I’m guessing that someone installed incorrect bearings on the carrier... does anyone have dimensions of the correct bearing sizes? I can try to measure what I have before I but new

I pulled the banjo out of my roadster. I drove it once and noticed some pretty loud howel on deceleration. What I know I think it’s a 40’ -The gearing has matched etching from ford that says 3.57 (I counted the teeth and it’s 3.54) the gear faces look really nice. - the spiders seem tight and...

Good banjo rear, ideally 3.54 gearing but let’s chat I’m seeing what’s out there before I attempt to rebuild my 40’ rear. 57-58” width. It’s a long shot but ya never know. Nice runner, rebuilt, quick change I suppose if the price were right. Willing to travel 500 miles from Denver to pickup...