Recent content by cobra2

I have many AR handbrake parts to sell. email cobratoo22@gmail.com.

As a follow up to my earlier post. I received the new top irons and they are new reproductions for a 30/31 RPU. To make them fit my '28 I only need to replace the back wood bow with one for a 28/29 which I have and narrow the front and center bows a couple inches. I have a set of irons that...

Somewhere I read that the 30/31 tops were removable. I wonder if this meant they had snaps at the rear bottom to disconnect them?

Thanks much Darryl

I wonder what the actual differences are.

Thanks I guess I will have to resell them.

Will 30-31 rpu top irons fit 28-29 rpu's? How much different are they? Thanks

I have a couple of these complete assemblies and would sell one.

I suppose a good bodyman could modify a couple rear fenders to make them look like the beavertails.

I bought two early squeeze type levers. On one the squeeze part is pressed steel all rusty. The other is a hollow cast alloy, looks like aluminum. You can see the injection spot on the inside. I'm going to use that one on my left side handbrake lever.

Charles, Are those rear fenders on your pickup?

Wow that is neat. Thanks Randy. I wonder if they used them on the pickups too.

I've heard that the first Model A rear fenders were different from later ones in the rear area. I have looked high and low for a picture of these but cannot locate one. Does anyone here have a picture of them? Thanks.

I have a short one I can lengthen if need be.

Bob, I'm bidding on that one. Wasn't sure it was the correct one though.