Recent content by clinton perry

This micrometer tool is to set single point tool bit on cylinder boring bar. Clinron

I have designed a very attractive and effective mirror which I have on 2 of my 1930 A's. Email me with your phone number and I will explain what I have. WRLP@aol.com Thanks and I look forward to hearing from you. Clinton

Chris Try burning a couple of plumbers candles a couple of days. Works good for cat smell in mu pump house. Good luck. Clinton

Y RON Has the answer. I just ordered 5 for my A`S. Thanks Ron. Clinton

Ca. Go to your nearest Mill supply vendor. Buy drill blanks (jobber length) the size that you need, take to your machinist and have him grind the configuration for your cutting need. Put flat on top. For set screw to nest against. Cut to length and go. Very inexpensive and good tool steel...

This happens often when you sand blast the plugs. You remove all the glaze from the porcelain and plug shorts from gas saturation. 30's and 40's this was common with rebuilt plugs from Western Auto and other suppliers. Would drive people crazy after changing the plugs, no start. Clinton

gridleak If tapers aren't too bad, They should lap with some valve compound. With out too much trouble. Good Luck. Clinton

Get some Persian blue. OR Lay out ink. Put on the shaft turn the fan lightly and you will have the whole picture. Clinton

Bill Get it clean and oil free and spay with clear lacquor. Will last for months. Clinton

Mark, please email me your phone number. I have devised a very useful and attractive mirror setup that will not injure your finish. Clinton Perry, WRLP@aol.com.