Recent content by CarPapa

Just finished the same process on a 59A engine. I had the most success by removing the retainer clip, then lightly tapping the valve up as high as it would go. This leaves a large enough opening between the bottom of the valve head and the top of the block to allow for the insertion of a thin...

Has anyone ever put a Mitchell into a '34 Tudor Sedan? I have tried to take measurements and it seems it would require cutting the floor and rear seat riser. It looks like it would fit if there was no suspension travel, but that is not realistic. Thanks.

Wanted to use one in my '34 sedan, but would have had to cut the seat riser and floor. Decided against it.

I haven't used this service, but am aware of a company in Kansas City that provides a liquid chrome process. Do not know if they sell a spray can or not... LPF Automotive - 816.241.4551

'39-'48 Transmission...78 case (has been bead blasted), 29 tooth cluster gear in great condition, 15 tooth main drive gear. 81A top (has small crack at top of housing). Fork is 91A (3"). Sliding gear is also in good condition. Did not include pictures of shafts, bearings, etc. Asking $235 +...

Ron - What year is this for? I have two housings from a '34. I am not sure if they are correct for what you want. Gary