Recent content by BruceKC

I just installed them and my measurments were the same. Place them in the freezer for 30 minutes and pack the inside with grease so the spring will not come out.

I just finished doing mine. Heat with acetylene only, no oxygen until just where you can still hold your hand on it. then wipe off the black soot. Keep weight on top as you slowly bend the arc to match the outline of the curve. Trace curve and lay out on top of plywood.

Thanks to all for the information.

Bratton's #30920 female dovetail goes inside the Door Post, the male dovetail on the door slides into the female dovetail. I cannot figure out how to get it into the door post.

Btt

Thanks Kevin, there are no dovetails in the channel at this time. I am trying to figure out how to get the new complete dovetail into the channel.

How do you install a complete female dovetail in a 31 S/W Town Sedan 160B 4 door?

How do you install complete female dovetail in a 31 Slant Windshield Town Sedan 160B 4 door?

6,000 miles in 2015

You need a normally closed relay. Use the tail light wire to one side of the closed contact and the other side to the buzzer. Ground the other side of buzzer. Connect the coil side of the relay with the key wire on the ignition coil and ground the other side of relay coil

After closely looking at the picture, the housing that is not closing up would be the right housing. are you sure you haven't switched the housings. you identified it as the left side.

I sent you a PM. Bruce

There are 32 OZ to a quart thus it was cheaper.

Thanks for the information on shortening the handle, Bruce

How did you shorten your emergency brake handle,Bruce