Recent content by bobs1938ford

I bought my 1934 5w std cpe in San Antonio in 1957 and drove back to Ohio in 1958, still have it! bob

I have several steering boxes/columns for 35-38 fords? If someone can tell me how to identify them. I will give away free but you pay postage and how to ship. Thanks, bob guthrie 1035 n county rd 198 fremont oh 43420 phone 419 307 5984

I have a 1934 ford wiring harness that is free to someone,,just pay postage! Bob guthrie 1035 n county rd 198 fremont oh phone 419 307 5984

think they are gone! bob

I have a complete front end(have had for years), spring, axle,tie rod back plates,hubs, drums,brakes, wheel cylinders. also have two LF fenders in good shape with no rust holes or bondo or dents(maybe surface rust only), also have a R front fender for same. cant ship but free if you can pick...

i was stationed in Alaska in the fifties and put a blow torch against the oil pan for 5-10 minutes to warm up th eoil to start it. bob

i have a couple of horns off a 34 i think(they are apart) that i would give away free for the postage' bob guthrie fremont oh

thanks for your replies, i will try to remove the rubber lining from one of the sleeves and see if i can get the bullets in and then electric tape or heat shrink tube. think i bought these from drake many years ago. thanks again bob

I need some advice/help with my headlite wiring harness. Put a new/used one on my 34 and have some questions. It seems to work as i checked with ohm meter to identify hi and lo beams. I am having a terrible time getting the bullet connectors in the sleeve connecting the harness to the pigtails...

Thanks, I have some old ones that I will practice on

Is there a way to clean these gauges up? Mine are pretty dirty and grungy looking. Thanks Bob

Just put one of these NOS harnesses on my 38 and can say very, very, very frustrating. Never did get it just right. Should have built my own. Been fooling with flatheads for 65 years and this task was the worst ever. bob

I restamped the frame on my 38 and was surprised on how hard I had to hit the stamp, really had to hit it. Used a lead hammer. bob